All-Sun EM272 Lambda Tester & Simulator can be used to Zirconia Titania Sensor Check. AllSun EM272 Automotive Sensor Simulator Tester For Test 1,2,3 and 4 Wires Sensors Durable ABS Enclosure Low Battery. All-Sun EM272 Automotive Exhaust Oxygen Sensor Tester Simulator use as Oxygen Sensor Tester to measure the crossover changes.

All-Sun EM272 Lambda Tester & Simulator AllSun EM272 Automotive Sensor Simulator Tester For Test 1,2,3 and 4 Wires Sensors Durable ABS Enclosure Low Battery

All-Sun EM272 Automotive Exhaust Oxygen Sensor Tester Simulator All-sun EM272 Lambda Tester and Simulator

All-Sun EM272 Lambda Tester & Simulator Identifying which wire the tester is connected to, i.e. groun, heater or ECU supply.
The tester allows the operator to verify which wire the tester is connected to
LED light path displays the Crossover signals of the Lambda sensor.
Rich or lean signal simulation to check ECU reaction.



All-sun EM272 Lambda Tester and Simulator Indicator Panel:

The lambda tester is designed to measure the crossover changes which occur int he closed loop control system.

This device able to indicate which wire on the lambda sensor the tester is connected to (ECU, open circuit, or ground). In additon, the presence of the heat generated from the supply voltage also can be identified by using this device.





The tester can be used to analyse zirconia or titania type sensor

All-Sun EM272 Automotive Exhaust Oxygen Sensor Tester Simulator Features

1.Tests 1, 2, 3 and 4 wire sensors.
2.Tests heated and non-heated sensors.
3.Identifies which wire the tester is connected to, i.e. Ground, heater or ECU supply(where applicable).
4.Rich or lean signal simulation to check ECU reaction.
5.Wire piercing clip for easy connection.
6.LED light path displays the crossover signals of the Lambda sensor.
7.Low battery indication
8.Sealed control switches for workshop environment.
9.Durable ABS enclosure.





AllSun EM272 Automotive Sensor Simulator Tester Specificatons:



Battery: 9V, 6F22 or equivalent, alkaline
Low Battery Indication: LED on the indictor panel lights
Operating Environment: -10℃ ~ 50℃, <75%RH
Storage Environment: -20℃ ~ 60℃, <85%RH
Size: 147 x 81 x 29 mm
Weight: about 250g

AllSun EM272 Automotive Sensor Simulator Tester Accessories and Packaging:




All-Sun EM272 Lambda Tester & Simulator Manual book
Black color bag
Ground clip (black) and wire- piercing clip (red)

All-Sun EM272 Lambda Tester & Simulator Note:

Battery not included

OBD2Store.com-- China OBD2 Tool, Automotive Diagnostic Tools, Car Key Programmer, OBD2 ECU chip tuning tool Center.

Contact information:

Website: www.obd2store.com
Email: info@obd2store.com
Skype: obd2store@outlook.com
Whatapp: +86-13682550935